![]() ![]() You will need to insert that plug into a grounded and fused power outlet. The Goplus welder comes with a 3 pin plug. And in this article you’ll find some supportive advice. You’re here because you are looking for something better. Once you have seen it you know you’re going to need some help. I’ve seen the Goplus MIG welder manual described as a waste of paper. Other Goplus MIG 130 Welder Articles On The Site.The Same Goplus 130 Welder Different Manufacturers.Welding With The Goplus And Its Controls.Slip The Contact Tip Over The Welding Wire. Once The Wire Appears At The Welding Torch Tip. Slowly Turn Up The Wire Feed Dial To Feed The Wire Through. Straighten Out The Hose To The Welding Torch. Feeding The welding Wire To The MIG Gun.Rotate The Pivot Arm Back And Tighten To Tension. Guide The Welding Wire Into The Incoming Wire Guide And Over The Drive Roller Into The Groove. Then Feed The Welding Wire Into The Wire Guide. Next, Put The Tensioning Spring Onto The spindle On Top Of The Large Nut. Put The Large Nut Onto The Spindle, On Top Of The Spool. Take Your Spool Of Flux Core Welding Wire. Installing Welding Wire Inside The Goplus Welder.Connecting Your Goplus MIG 130 To Power. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |